Articles in this section

Warm-ups and Starting Weights

Below is a starting guide for specific warm-ups for your exercises. Do not worry about being precise in rep max estimation; simply get moving and go from lighter to heavier weights. We recommend you do not log warm up sets in the app, as the app treats all sets logged as working sets. 

 

  1. 12 reps with a weight you could do for 30 or more Example: squat - barbell for 12 reps

  2. 8 reps with a weight you could do for 20 reps. Example: squat - 95 pounds for 8 reps

  3. 4 reps with a weight you could do for 10 reps. Example: squat 135 x 4 

  4. Working sets with a weight you can hit 3RIR within your chosen rep range 

Tips: 

  • we recommend challenging weights in the 5-10 rep range for beginners 

  • weights in the 5-20 rep range for intermediates.

  • any load in the 5-30 rep range is good. See Recommended Rep Range  

  • resting as much time in between each set as gets you breathing normally and feeling strong again

  • later exercises may only need 1, 2, or even 0 warm-up sets

Know your max?

If you know your one-rep max (1RM), you can use it as a rough starting point. RP recommends training with weights between about 30% and 85% of your max. That works out to roughly 5 to 30 reps if you took the first set to failure. 

  • Heavy (5 to 10 reps): the top of that range, up to about 85% of your max.
  • Moderate (10 to 20 reps): a middle weight. Most of your sets should be here.
  • Light (20 to 30 reps): a lighter weight, down to about 30% of your max.

These are estimates. Your first week still comes down to RIR, so pick a weight that leaves you at your RIR target in the rep range you chose, and the app adjusts from what you log. If you don't know your max, you don't need it. The warm-up method above works just as well.

New or replaced exercise? The app has no data for it yet, so it doesn't suggest a weight. Use the same warm-up ladder, then pick a working weight that leaves you at your RIR target. See Replace an Exercise

Don't know your max?

You don't need it. Most people find their working weight during the warm-up.

  1. Work up through the warm-up ladder above, or one you are familiar with. Each step tells you how heavy the next one should feel.
  2. For your first working set, pick a weight you think you could lift for your target reps plus about 3 more. That's 3 reps in reserve.
  3. Do the set and see how close you were. If you could have done a lot more, go a little heavier on the next set. If you barely made your reps, go a little lighter.
  4. Log what you actually did. Week 1 is for finding your weights, so it's fine if the first set is off.

Example: using the squat from the ladder above with a target of 5 to 10 reps. Your last warm-up was 4 reps at 135 lb, a weight you could lift about 10 times. That means 135 lb should give you about 7 reps with 3 left, inside your range, so start your first working set there.

When in doubt, start lighter. It's easier to add weight next week than to recover from a set that was too heavy.

If you'd like a deeper dive with slightly different suggestions on warming up and selecting weights, give these two videos on the topic a watch:

 

 

 

 

 

 

Was this article helpful?
0 out of 0 found this helpful